Setting up your PT-JOY-G3

The PT-JOY-G3 utilizes a VISCA-based command set over TCP/IP for PTZ camera control. This guide covers the basic setup process for the PT-JOY-G3 joystick controller.

---

Step 1: Requirements

Before setup, make sure you have the following:

• PT-JOY-G3 Joystick Controller — Easily identified by its six (6) CAM buttons on the left panel.

• PTZOptics Camera — (Note: While other brands may work, compatibility is only guaranteed with PTZOptics cameras.)

• Network Infrastructure — A Network switch, router, or an existing LAN is sufficient.

  ⚠️For best results Ensure the joystick and cameras are on the same subnet.

• Cat5e or Better Network Cables — Also known as Ethernet or network cables, used to connect devices to your network.

• Computer — Suggested for initial camera setup (if not already configured).

---

Step 2: Camera Setup

Ensure your PTZOptics cameras are:

• Connected to the network

🔧 Network Setup Resources: Camera Network Setup Guide will walk you through connecting the camera to your network.

---

Step 3: Joystick Setup

1. Connect the Joystick — Plug the joystick into your switch/router.

   • If using a PoE switch , no separate power supply is needed.

   • If not PoE-capable, use the included power adapter .

2. Assign IP Address (if DHCP is not available on the network)

   • Press the SETUP button on the joystick.

   • Scroll to IP Settings (3rd option).

   • Change to Static , then:

     • IP Address (e.g., 192.168.100.90 )

     • Subnet Mask (e.g., 255.255.255.0 )

     • Default Gateway (e.g., 192.168.100.1 )

   • Press Enter to confirm or ESC to discard.

   • The joystick will restart to apply changes.

---

Step 4: Add Cameras to Joystick

1. Press the SETUP button.

2. In the menu Scroll to the right until you reach add device and hit enter.

3. Choose a camera ID (1–254).

   ⚠️ IDs 1–6 map to the six CAM select buttons.

4. Enter the camera’s IP address (e.g., 192.168.100.101 ).

5. Choose control type :

   • UDP – Port 1259

   • TCP – Port 5678

6. Confirm settings. The camera is now ready for control.

✅ Test camera control by pressing the assigned CAM button and using the joystick to pan, tilt, or zoom.

🔁 Repeat for all additional cameras.