Connections

Studio SE Connection List

1. Standby LED
2. RS-485 Interface
3. Power LED
4. Line Output
5. LAN NDI
6. HDMI
7. 3G-SDI
8. USB Service Port
9. USB 3.0
10. DC 12V Power
11. Line Input

Serial Connection Guide

Serial refers to the RS-232 and RS-485 connections from the camera to a joystick controller using the same connection.

RS-232 Overview

This uses an 8 Pin Mini-Din connector.

No.	Function
1.	DTR
2.	DSR
3.	TXD
4.	GND
5.	RXD
6.	GND
7.	IR Out
8.	NC

Initial Connection

Camera	Windows DB-9	Connection Direction
1. DTR	CD	Camera DTR to Windows DTR & CD to none
2. DSR	RXD	Windows TDX to Camera DSR
3. TXD	TXD	Camera TDX to Windows RXD
4. GND	DTR	Camera GND to Windows GND
5. RXD	GND	Two way from Camera RXD to Windows TDX
6. Unused	DSR	None
7. Unused	Unused	None
8. Unused	Unused	None
9. Unused	Unused	None

Daisy Chain Control Connection

Camera	Mini DIN	Connection Direction
1. DTR	DTR	Camera DTR to Windows DSR & CD to none
2. DSR	DSR	Windows DTR to Camera DSR
3. TXD	TXD	Camera TDX to Windows RXD
4. GND	GND	Two way from Camera GND to Windows GND
5. RXD	RXD	Windows TDX to Camera RXD
6. Unused	Unused	None
7. Unused	Unused	None
8. Unused	Unused	None

RS-232 Parameters

• Baud Rate: 2400, 4800, 9600 or 38400 bps
• Start Bit: 1 bit
• Data Bit: 8 bits
• Stop Bit: 1 bit
• Parity Bit: None

RS-485 Overview

The left phoenix connector port is Positive (+)The right phoenix connector port is Negative (-).

The camera can be controlled via RS-485, Half-duplex mode, with support for VISCA, Pelco-D, or Pelco-P protocol.

RS-485 Parameters

• Baud rate: 2400/4800/9600/38400;
• Starting position: 1 bit
• Data bit: 8 bits
• Stop bit: 1 bit
• Check digit: None

note

To utilize an RS-485 connection, you will need an unterminated two-conductor cable

1. Connect the positive (red) wire to the camera’s positive phoenix connector port (left).
2. Connect the negative (black) wire to the camera’s negative phoenix connector port (right).
3. Connect the positive and negative wires to the positive and negative ports on your joystick controller.
   • To connect multiple cameras, you have the option to connect via daisy-chain or home run.
4. In either method, multiple wires will be connected to a single phoenix connector port