INOGENI

The INOGENI CAM230 is a hardware USB/IP capture and switching device that supports a REST API for automated input switching.

No Username/Password Auth

Voice Tracking does not support username/password authentication with the INOGENI CAM230. Leave the Username and Password fields blank.

INOGENI & IP2USB

The setup for the INOGENI IP2USB is identical to the CAM230, as both devices share the same API and connection method. Follow the same steps below to connect either device.

Step 1: Get the INOGENI Connection Details

1. Connect the INOGENI CAM230 or IP2USB to your network.
2. Find its IP address from your network's DHCP table or the INOGENI management interface.
3. Note the Port (default: 80).

Step 2: Configure the Switcher Connection

In the Voice Tracking configuration menu, click the Switcher tab and enter:

Field	Value
Switcher Type	INOGENI CAM230 or IP2USB
IP Address	IP address of the INOGENI CAM230 or IP2USB
Port	Communication port (default: 80)
Auth Token	Authentication token if using INOGENI IP2USB

Step 3: Start the Switcher

Click Start Switcher. A success message will confirm the connection is active.

Stopping the Switcher

To disconnect from the switcher at any time:

• Click Stop Switcher in the Voice Tracking toolbar (the same button used to start it).
• The switcher connection will close immediately.
• The microphone connection remains active unless you also click Stop Microphone.

Zone-to-Source Mapping

After the switcher is connected, map each zone to the correct switcher source:

1. Click a zone header on the zone map.
2. In addition to the Camera and Preset dropdowns, a Switcher Source field is available.
3. Select the input/scene number that corresponds to the camera covering that zone.

For multi-camera setups where multiple zones share one camera, assign the same switcher source to each zone within that camera's field of view.

Troubleshooting

Symptom	Likely Cause	Resolution
Start Switcher fails immediately	Wrong IP, port, or credentials	Verify connection settings; confirm switcher is running and reachable
Zones activate but no cuts happen	Switcher connected but sources not mapped	Verify zone-to-source assignments in the zone map
INOGENI cuts not happening	Credentials entered (should be blank)	Clear Username and Password fields
Cuts happen with wrong camera	Zone-to-source mapping incorrect	Re-check zone assignments and verify input/scene numbers
Switcher connects but immediately disconnects	Firewall blocking the port	Verify firewall allows traffic on the configured port between the camera and switcher

Next Steps

With the switcher connected, return to Zone Configuration to assign switcher sources to each zone.